Suspended Timber Floor Insulation Building Regulations

Read more about changes to thermal elements in the external walls section previous building regulations.

Suspended timber floor insulation building regulations.

Suspended timber floor as a requirement of the building regulations the structure should be protected against the growth of weeds and other plant life. Timber suspended floor ground preparation remove top soil and vegetation apply total weed killer and 150mm min thick sand blinded hardcore then either i provide concrete ground cover of at least 100mm thick or ii prepare the ground to an even surface and lay a ground cover of concrete at least 50mm thick on. To meet the part e building regulations in this scenario you need to achieve the following db figures and the test is based upon both airborne noise and impact. For optimum results when addressing heat loss through a suspended timber floor the specification needs to ensure that high levels of thermal performance delivered by the insulation material are combined with airtightness and moisture control while at the same time facilitating a degree of breathability.

Installing any amount of insulation will warm the floorboards and go a long way towards eliminating draughts. A suspended timber floor tends to be cold and draughty because of the air circulating beneath it. Suspended timber floor as a requirement of the building regulations the structure should be protected against the growth of weeds and other plant life. Renovation of more than 25 per cent of a solid or suspended floor involving the replacement of screed or a timber floor deck would have to meet the standards required by the building regulations approved documents.

Care must be taken however not to harm the character and significance of the building or impede subfloor ventilation for example by blocking air vents so promoting timber decay. The effect is a greater sense of comfort and that in turn allows the homeowner to turn the thermostat down. Span the timber specific to the spacing and. Insulating and draught proofing an old suspended timber floor at ground or upper storey level above unheated spaces can save considerable energy.

To make sure the insulation boards are flush with the top surface of the joists they should be supported on minimum 25 mm x 25 mm treated softwood timber battens proprietary galvanised steel saddle clips or galvanised nails partially driven into the side of the joists. The ground should have a layer of concrete poured across and there should be a ventilated gap of at least 150mm between the underside of the timbers and the concrete to prevent moisture.