Start Hanging Wallpaper Feature Wall

This has been made simpler because there s no need to apply the paste to the wallpaper fold it and let it soak in before hanging it.

Start hanging wallpaper feature wall.

Remove electrical outlet and light switch covers. You can use a spirit level instead if you prefer. When it is time to switch things up use water to dampen one of the fabric s edges and slowly peel off. Hang wallpaper to create a feature wall hanging wallpaper isn t as complicated as it might seem thanks to new techniques like paste the wall wallpaper.

Mix the wallpaper paste with the amount of water that it says on the packet and leave it to stand for a few minutes. Cut from the part of the pattern that matches the paper on the wall around the switch. Wash any dirt or dust from the old walls and sand smooth any chipped paint. Slide the wallpaper into position lining up with the plumb line.

The first length is hung with its edge on the mid point line. You then continue to hang full lengths either side of this until you reach the corners. Decorator for 30 years harry anstice shows you how to wallpaper a feature wall quickly and effectively. Notice that you are left with two narrower lengths in this situation one full length can be cut in half.

Use a plumb line or spirit level to mark a line where you can hang the first piece. Wallpaper from cole and son wallpapers donated by www. Here are the steps to planning for success. Using a plumb line and pencil mark a vertical line on the wall.

Although seam planning. If you re hanging wallpaper on new drywall prime the wall first with wallpaper primer to seal the drywall and help the paper adhere to the wall. Apply paste to the plate then lay it face down on the paper. To avoid unpleasant surprises that result from poor seam placement or having patterns cut off in awkward places don t rush into.

Plan to lay seams where they ll be the least noticeable. Cut a piece of paper a few inches longer than you need. Next pull out the tacks and remove excess fabric along the ceiling and corners with a box cutter. Remove old wallpaper using wallpaper remover a wide blade and rags.

Hold them both on the wall and adjust the paper to match the pattern on the wall. Cut a piece of wallpaper larger than the plate. The seam should be exactly on the line and plumb. How to wallpaper a feature wall.

Hang first strip start at your plumb line and ensure the pattern is right side up. Apply the top half of the strip to the wall slightly overlapping the ceiling and adjoining wall. If the window is the only feature in the room that you can use as your starting point measure the window and mark the center line. Which is the dominant wall.